Basler Vision Technologies BIP-1600c-dn Manual de usuario descargar pdf (Pagina 28)

Configuring the Camera

24 Basler IP Camera

Click the Motion Mask button to open the Motion Mask Editor as shown below.

The motion mask defines the area(s) of the image that will be used for the camera’s

motion detection function (see Section 3.5 on page 33). Highlighted areas in the

editor will be included in the motion detection mask and used for motion detection.

Unhighlighted areas will not. To highlight an area within the editor, simply left click

your mouse and drag the cursor over the editor screen.

Note that you can set the mask so that it covers a single area as shown above or

so that it covers several different areas within the image.

You can use the All On button at the bottom of the screen to highlight all areas of

the editor and the All Off button to unhighlight all areas. Use the Invert Mask button

to swap the highlighted areas and the unhighlighted areas. Clicking the Load Mask

From Camera button will display the mask settings that are currently saved in the

camera.

Any changes you make using the mask editor will not be saved in the camera until

you click the Save Mask To Camera button. The Close button will close the editor.

Motion Mask

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 95 96

Sin comentarios

Basler Vision Technologies BIP-1600c-dn Manual de usuario Pagina 28